Siemens SIMODRIVE POSMO A User Manual page 47

2 Installing and Connecting–Up
2.3 Connection and wiring overview
Connection cover
Changing the
cable outlet
direction
Screws
Dummy plug 2
Dummy plug 1
Fig. 2-16 Connection cover: Changing the cable outlet direction
2-46
The cable outlet direction is, as standard, in the opposite direction to
the motor drive shaft.
Depending on the mounting situation, the cable outlet direction of the
positioning motor can be changed.
How can the cable outlet direction be changed?
––> refer to Fig. 2-16
1. In the unwired connection cover, release the four screws of the con-
nection module.
2. Rotate the connection module and screw back into place.
3. Interchange the load current and PROFIBUS cabling in the connec-
tion cover at the top.
Connection module
Screws
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Connection cover
from the bottom
Screw type: Cheese–head screw
M3 x 6 – 8.8
SN 60730
Torx T10
max. 1.8 Nm
Connection cover
from the top
After turning the connection module,
connect–up as follows:
S
Dummy plug 1
––> reserved
S
Dummy plug 2
When this connection is used, the
dummy plug is replaced by a PG11 PG
gland for the digital input/output cable.
S
The interchanged cables should be
appropriately connected–up.
Refer to Chapter 2.4.3
E Siemens AG 2013 All Rights Reserved
08.03 02.99