Siemens SIMODRIVE POSMO A User Manual page 52

06.05 02.99
2.4 Mounting SIMODRIVE POSMO A
2.4.1 Mounting overview
The following steps are required when mounting a SIMODRIVE POSMO A:
Mounting and
installation steps
Thoroughly remove all anti–corrosion agents from
the shaft end (use typical solvents)
Release the SIMODRIVE
POSMO A connection cover
Mount the SIMODRIVE POSMO A motor without
connection cover (refer to the dimension drawings in
Chapter C)
Prepare the connection cover for mounting:
S
Prepare the cable
S
Install the cables in the connection cover
S
Set the PROFIBUS node address
S
Switch 8 setting OFF for PROFIBUS communications
S
Set the PROFIBUS terminating resistor
Locate the connection cover on the SIMODRIVE POSMO A and tighten the 2 screws
retaining the cover (max. tightening torque, 1.8 Nm)
Connect the protective and potential bonding conductors
Switch–on the power supply for the load and electronics
S
Load power supply (if no independent electronics power supply is present)
S
Load and electronics power supply (if both of the power supplies are separate)
LED?
dark?
or
red steady light?
Fig. 2-17 Mounting and installation steps
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
2.4 Mounting SIMODRIVE POSMO A
yes
Troubleshooting/diagnostics
––> Refer to Chapter 6
no
Commission the drive system
––> Refer to Chapter 3
2 Installing and Connecting–Up
Warning:
Protect an open drive
against dirt
––> refer to Chapter 2.4.2
––> refer to Chapter 2.4.3
––> refer to Chapter 2.3.1
––> refer to Chapter 2.3.1
––> refer to Chapter 2.3.1
––> refer to Chap. 2.3.2
2
2-51