Siemens SIMODRIVE POSMO A User Manual page 230

02.99 08.06 04.01
P0973 / 3CD Actual block number and checkback byte/n-actual
300W 075W
Min Standard
– –
For the complete PZD status, the actual block number and the return byte in the PKW channel
are signaled here.
Note:
Available from SW 1.4.
The following applies from SW 2.0:
The actual speed value is returned using these bits in the "Speed setpoint" operating mode
(P930).
The actual value represents the speed at the gear output.
0980:116 / 3D4 Supported parameters
300W 075W
Min Standard
– –
All of the parameters supported by the device are listed here in an increasing sequence.
P980:0 ––> no significance
P980:1 = 1 (P1)
...
P980:77 = 990 (P990)
0990:116 / 3DE Changes with respect to the factory default
300W 075W
Min Standard
– –
All of the parameters which have been changed over the factory default are listed here in an
increasing sequence.
P990:0 ––> no significance
P990:1 = 4 (e.g. P4)
P990:2 = 990 (P990)
P990:3 = after the end of the list
Note:
For parameters with index, the parameter number is listed if at least 1 parameter of the array
was changed.
P1426 / 592 Tolerance band for actual setpoint value
300W
Min Standard
0 100
075W
Min Standard
0 100
This parameter defines the tolerance band for the actual speed value.
If the actual speed value is within this tolerance band around the specified setpoint, the bit
"Speed within tolerance band" is output (ZSW.8).
Note:
This parameter is visible in SimoCom A only in operating mode "Speed setpoint" (P930).
Available with software version 2.0 and higher.
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
5.6 Parameters for SIMODRIVE POSMO A
Max Unit
– Hex
Max Unit
– –
Max Unit
– –
Max Unit
3800 rpm
Max Unit
3600 rpm
5 Description of the Functions
Data type Effective
V2 RO
Data type Effective
I2 RO
Data type Effective
I2 RO
Data type Effective
C4 immed.
Data type Effective
C4 immed.
5
5-229