Safety Guidelines - Siemens SIMODRIVE POSMO A User Manual

08.04 04.01
1.3

Safety guidelines

Reader's note
In addition to the technical information/instructions specified in the
foreword to this documentation, the following danger and warning
information/instructions should be carefully observed when using
SIMODRIVE POSMO A!
Danger
!
1. In order to avoid danger and damage, the data and instructions in
2. All of the work must be carried out by qualified, appropriately
3. Before starting any work on SIMODRIVE POSMO A, the motor
4. All of the rating plates, warning labels and information labels on the
5. Commissioning is prohibited until it has been clearly identified that
6. Caution when coming into contact! When SIMODRIVE POSMO A
7. Use in hazardous areas is not permitted.
8. The load power supply (48 V/24 V) and electronics power supply
Warning
!
9. Never disable protective functions and devices even for trial
10.For shaft ends with key, the key must be secured when operated
11. Check the direction of rotation with the motor uncoupled.
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
all of the documentation associated with this product should be
carefully observed. Please refer to the Catalogs or contact your
local SIEMENS office for the ordering data.
trained personnel.
must be disconnected in–line with the regulations according to the
5 safety rules. In addition to the main circuits, it is important to
observe if there are any supplementary or auxiliary circuits.
The "5 safety rules" according to DIN VDE 0105:
Disconnect, lock–out to prevent reclosure, ensure that the
equipment actually is in a no–voltage condition, ground and
short–circuit and cover or partition off adjacent parts under voltage.
The previously mentioned measures may only be reversed/restored
after all of the work has been completed and the motor has been
completely installed.
SIMODRIVE POSMO A must be carefully observed!
the machine, in which this component is to be installed, fulfills the
conditions of Directive 98/37/EC.
is operational, surface temperatures of over 100 _C can occur!
Danger of fire!
(24 V) are not galvanically isolated.
operation.
under trial conditions without drive–out element.
1 Product Brief
1.3 Safety guidelines
1-25
1