Panasonic FP7 Series Command Reference Manual page 1066

17.34 CIPMGET (CIP Message Data Getting)
Status code Status name
0x16 Object instance does
not exist
0x17 Service fragmentation
out of sequence
0x18 No stored attribute
data
0x19 Store operation failure
0x1A Routing failure,
request packet too
large
0x1B Routing failure,
response packet too
large
0x1C Missing attribute list
entry data
0x1D Invalid attribute value
list
0x1E Embedded service
error
0x1F Vendor specific error
0x20 Invalid parameter
0x21 Write-once value or
medium already
written
0x22 Invalid Reply Received An invalid response is received (for example, reply service code
0x23 Buffer Overflow
0x24 Message Format Error
0x25 Key Failure in path
0x26 Path Size Invalid
0x27 Unexpected attribute in
list
0x28 Invalid Member ID
17-178
Description
The specified object does not exist in the device.
The fragmentation sequence for this service is not active for this
data.
The attribute data of this object was not stored before the requested
service.
The attribute data of this object was not stored due to a detected
error during the attempt.
The service request packet was too large for transmission on a
network in the path to the destination. The routing device was forced
to stop the service.
The service response packet was too large for transmission on a
network in the path from the destination. The routing device was
forced to stop the service.
The service did not provide an attribute from the attribute list
required by the service to perform the requested behavior.
The service returns the list of attributes that contains status
information about invalid attributes.
An embedded service resulted in an error.
A vendor-specific error was detected. The additional code field of the
error response specifies the detected error. This general error code
must only be used if none of the error codes displayed in this table
or in an object class definition accurately represents the detected
error.
A parameter associated with the request was invalid. This code is
used if a parameter does not comply with the requirements of this
specification and/or the requirements defined in an application object
specification.
An attempt was made to write to a write-once medium (for example,
WORM drive, PROM) that has already been written. Or, an attempt
was made to modify a value that cannot be modified once
established.
does not correspond to the request service code, or the response
message is shorter than the minimum expected response size). This
status code can be used for other purposes of invalid responses.
The message received is larger than the receiving buffer can handle.
The entire message was discarded.
The format of the received message is not supported by the server.
The key segment that was included as the first segment in the path
does not correspond to the target module. The object-specific status
must specify which part of the key check was unsuccessful.
The size of the path sent with the service request is either not large
enough to allow the request to be forwarded to an object, or too
much routing data has been included.
The attribute cannot be set at this time.
The member ID specified in the request does not exist in the
specified class/instance/attribute.
WUME-FP7CPUPGR-12