Panasonic FP7 Series Command Reference Manual page 1031

■
Precautions for programming
● Insert the UNITSEL instruction immediately before this instruction and specify the unit (built-
in ET-LAN in the CPU unit) and the connection number.
● For [S1] and [S2], specify the starting address of the device storing the string data which
indicates the set parameters or a character constant. When specifying a device area for an
operand, set string data using the SSET instruction in advance. However, the ESSET
instruction cannot be used because the format is different.
● Both upper and lower case characters can be used. "Abcd", "ABCD" and "abcd" are all
synonymous.
● This instruction is not available in interrupt programs.
■
Setting of [S1] and [S2]
Setting
Settings
item
S1 Read type
S2 Read target
(Note 1) The RUN/IDLE bit monitor is available for the CPU unit Ver.4.11 or later.
■
Setting of [S2] and targets to be read
● The read contents vary according to the character string set in [S2].
● The number of read words varies according to the maximum registered node number.
Name
Registered
maximum node
number
Cyclic
communication
registration node
table
(Note 3)
WUME-FP7CPUPGR-12
17.28 ETSTAT (Acquiring EtherNet/IP Information)
For specifying the read of the EtherNet/IP
communication state
For specifying the communication state of
EtherNet/IP
For specifying the cyclic communication
registration node table
For specifying the cyclic communication normal
node table
For specifying the cyclic communication stop node
table
For specifying the cyclic communication abnormal
node table
For specifying the RUN/IDLE bit monitor (PLC
standby flag)
Character string set in [S2] and read object (●: Read, Blank: Not read)
Number
of words
ALL
(Note 1)
1 ●
0 to 16 ●
ALL +
Number
NODE NORMAL
(1 to 16)
(Note 2)
●
● ●
Specify "EIP".
Specify "ALL" or "ALL +
Number".
Specify "NODE".
Specify "NORMAL".
Specify "STOP".
Specify "ERR".
Specify "PLC".
STOP ERR PLC
17-143