Panasonic FP7 Series Command Reference Manual page 1069

Set bit 0 (R1000) and bit 1 (R1001) in WR100 to "1" and execute the EIPSTART instruction.
15
16
32
Node
number
256 255 254 253
■
Operand [n] setting
● Specify the device address storing the maximum node number or a constant.
● The number of valid words for the start request node number table varies (from 1 to 16
words) according to the maximum node number that is specified by [n].
Maximum node number
■
Operand [D] setting
Specify the device address storing execution results.
Code Status
0 Normal end
1 In progress
2 Start failed
Multiple
3
executions
■
Relay operation
When the cyclic communication start request instruction is executed and the cyclic
communication of the specified node starts normally, the cyclic communication normal node
table for the node is turned ON and the cyclic communication stop node table for the node is
turned OFF.
WUME-FP7CPUPGR-12
17.35 EIPSTART (Cyclic Communication Start Request)
14 13 12 11
15 14 13 12
31 30 29 28
252 251 250
0
1 to 16
17 to 32
33 to 48
49 to 64
:
225 to 239
241 to 256
Description
The specified node start is complete.
The specified node start processing is in progress.
The specified node start failed.
Multiple execution of the EIPSTART instruction or the EIPSTOP instruction
Bit No.
10 9 8 7
11 10 9 8
27 26 25 24
:
249 248 247 246 245
6 5 4 3
7 6 5 4
23 22 21 20
244 243 242
Number of valid words
0
1
2
3
4
:
15
16
2 1 0
3 2 1
19 18 17
241
17-181