Panasonic FP7 Series Command Reference Manual page 1065

Name
■
CIP status codes
Status code Status name
0x00 Success
0x01 Communications
Related Problem
0x02 Resource unavailable
0x03 Invalid parameter
value
0x04 Path segment error
0x05 Path destination
unknown
0x06 Partial transfer
0x07 Connection lost
0x08 Service not supported
0x09 Invalid attribute value
0x0A Attribute list error
0x0B Already in requested
mode/state
0x0C Object state conflict
0x0D Object already exists
0x0E Attribute not settable
0x0F Privilege violation
0x10 Device state conflict
0x11 Reply data too large
0x12 Fragmentation of a
primitive value
0x13 Not enough data
0x14 Attribute not supported The attribute specified in the request is not supported
0x15 Too much data
WUME-FP7CPUPGR-12
Description
To be set when [D1] (offset position) exceeds the value of the 1st word (total number of data)
of [S1] (CIP message) before processing.
To be set when [D1] (offset position) exceeds the value of the 1st word (total number of data)
of [S1] (CIP message) after processing.
17.34 CIPMGET (CIP Message Data Getting)
Description
Execution of the service by the specified object was successful.
A connection-related service was unsuccessful along the connection
path.
The resources required for the object to perform the requested
service were not available.
To select the correct value for this condition, refer to Status Code 20
(hexadecimal number).
The path segment identifier or segment syntax was not interpreted
by the processing node. Path processing is stopped if an error
occurs in the path segment.
The path references an object class, instance, or structural element
that is not identified or contained in the processing node. Path
processing is stopped if a path destination unknown error occurs.
Only part of the expected data was transferred.
The messaging connection was interrupted.
The requested service was not implemented. Or, it was not defined
for this object class/instance.
Invalid attribute data was detected.
An attribute in the Get_Attribute_List or Set_Attribute_List response
has a non-zero status.
The object is already in the mode/state being requested by the
service.
The object cannot perform the requested service in the current
mode/state.
The requested instance of the object to be created already exists.
A request to modify a non-modifiable attribute was received.
A permission/privilege verification was unsuccessful.
The device cannot perform the requested service in the current
mode/state.
The data transmitted in the response buffer is larger than the
allocated response buffer.
The service specified an operation that is going to fragment a
primitive data value, i.e. half a REAL data type.
The service did not supply enough data to perform the specified
operation.
The service supplied more data than was expected.
17-177