Panasonic FP7 Series Command Reference Manual page 1085

Hide thumbs Also See for FP7 Series:

Table of Contents

Type of FP7 device specified

16-bit device.

WX, WY, WR, WL, DT, LD

1-bit device.

X, Y, R, L, DT.n, LD.n

● The amount of sent data [n] is specified in words for the register transfer and in bits for the bit

● For the operand [D1], specify hexadecimal data that consists of the destination device code

and the device address of a partner unit.

Example) When the device code is 3 (internal relay) and the upper hexadecimal 2 digit of the

device address is H00, specify H300.

● For the "high byte of [D1]" that is the device code of the partner unit, specify one of the

following values.

● For the device address of the partner unit, specify six-digit hexadecimal (three-byte) data that

consists of the low byte of [D1] and the value of [D2]. When the device address is in the

range of H0 to H00FFFF, specify "H00" for the low byte of [D1].

Execution result code [D3]

The communication port is being used in the

master communication.

The communication port is being used in the

slave communication.

The number of master communication

instructions simultaneously used is exceeded.

It occurs when an abnormal telegram is received. When there is a format error in the header of an

individual protocol, the communication discards the received data and a response reception timeout

WUME-FP7CPUPGR-12

Bit transfer

Internal relay

Data register

File register

Link register

17.39 SEND (MC Protocol Master)

Transmission timeout

Response reception timeout

Reception error

I/O allocation shortage error

When the number of sent data is odd, 4-bit

dammy code H0 is added.

High byte of [D1]