•
SP 1-105-107
•
SP 1-105-137
•
SP 1-105-111
Side effects: Paper curl may occur.
Workaround D':
Increase the target fusing temperature by 5 more degrees using the following SPs:
•
SP 1- 105-019: 145 deg -> 150 deg -> 155 deg
•
SP 1- 105-023: 130 deg -> 140 deg -> 145 deg
•
SP 1- 105-027: 135 deg -> 140 deg -> 145 deg
•
SP 1- 105-141: 140 deg -> 145 deg -> 150 deg
•
SP 1- 105-115: 120 deg -> 125 deg -> 130 deg (For 1200 dpi mode)
Side effects: Paper curl may occur.
CPM information
Plain paper
Mid-thick
Thick paper 1
Thick paper 2
Thick paper 3
Thick paper 4
Troubleshooting for Toner Density
Symptom:
The image density decreases with continuous printing, especially in solid image areas (though it is within
specification).
•
This does not occur in text areas.
Cause:
This may occur due to the condition of the developer, and also occurs more easily when repeat prints are made
from the same original.
Solution:
Change the following SP modes as shown.
•
SP3-629-001 (Vc Vsp): Set to 530
•
SP3-629-101 (Vb Vsp): Set to 330
•
This will increase the amount of toner used to develop the image.
6.Troubleshooting
CPM
60
50
30
18
18
18
629