Ricoh SP 8400DN Field Service Manual page 1267

SC No. Type
•
•
•
•
•
•
•
•
SC503- B 3rd Tray Paper Position Error (LCIT: M496)
34
During left/right tray set, or when power is switched ON, or when transfer is complete,
"open" is detected 5 times consecutively by end fence open/close detection.
(The message of resetting the tray is displayed when the both sensors detect the error
consecutively 4 times or less.)
•
•
•
•
•
•
•
•
•
•
•
SC503- B 3rd Tray Transfer Error (LCIT: M496)
•
35
•
•
•
•
•
•
Error Name/Error Condition/Major Cause/Solution
Foreign matter, such as paper scrap, is caught inside the right tray.
Reset the paper.
Remove the foreign matter.
Reset the connector.
Replace the harness.
Replace the upper limit sensor.
Replace the lower limit sensor.
Replace the controller board for the LCIT (M496).
Paper set fault (paper is offset from position for pushing end fence)
Foreign matter entry (foreign matter is caught in the position for pushing end fence)
Paper transport cover open/close switch error, connector missing
Harness broken
Bank controller board defective
Reset the paper.
Remove the foreign matter.
Reset the connector.
Replace the harness.
Replace the sensor.
Replace the controller board for the optional paper feed tray.
Transfer end detection error
At right tray paper end (right tray lower limit detection, left tray paper detection), left
tray paper is transferred to the right tray, but the left tray paper sensor is detected
although a predetermined time elapsed (transfer paper missing is not detected), for 3
times consecutively.
(The message of resetting the tray is displayed when the both sensors detect the error
consecutively 2 times or less.)
Paper transfer motor error/connector missing
Left tray paper sensor error/connector missing
Harness broken
Bank control board defective
Paper overload
Foreign matter, such as paper scrap, is caught between the left tray and the paper tray
6.Troubleshooting
529