# Cancel key is not displayed.
•
Turn ON spanner LED (same as when an SC is generated).
Operation during SC reboot
•
Timing of SC reboot
When @Remote is enabled, and when a NRS alarm*1 is not generated, the corresponding SC is the object of
an automatic reboot.
*1 NRS alarm: Issued when an ordinary SC (type D) is generated twice while the total counter counts 10
times.
•
Time to automatic reboot
Reboot is performed 30 seconds after an engine reboot is possible, after the end of post-processing during
printing, etc.
At that time, a reboot is performed even if the printer is operating. The engine does not start process control
when a reboot is possible.
•
Automatic reboot
See the flowchart below.
6.Troubleshooting
503