Ricoh SP 8400DN Field Service Manual page 1240

6.Troubleshooting
•
When automatic reboot occurs twice continuously, an SC is displayed without rebooting, and logging
count is performed. Also, when an SMC print is output, an * mark is added alongside the SC number for
clarity.
•
Automatic reboot can be enabled or disabled with SP5-875-001 (SC automatic reboot setting) (default
value: OFF).
SP descriptions
•
SP5-875-001 (SC automatic reboot: Reboot Setting)
Enables or disables the automatic reboot function when an SC error occurs.
0: The machine reboots automatically when the machine issues an SC error and logs the SC error code. If the
same SC occurs again, the machine does not reboot.
1: The machine does not reboot when an SC error occurs.
The reboot is not executed for the pattern A or C.
SC Logging
When an SC is generated, the "total count value when the SC is generated" and the "SC code" are logged.
However, if the total count value during the SC is the same as last time, logging is not performed.
Logged data can be checked by outputting an administrative report (SMC print). The SC history is logged up to
the last 10 entries, and if there are more than 10 entries, data are progressively deleted starting from the oldest.
SC Automatic Reboot
When an ordinary SC (pattern D) is generated, automatically reboot is performed. Automatic reboot or reboot by
user operation can be set by SP5-875-001 (SC automatic reboot setting out) (default value: 1 "OFF").
When a type D occurs, automatic reboot is done or the machine display asks the customer if it can reboot.
However, when the SC occurs twice in a short time, the machine sends a report to the @Remote server without
rebooting. This is because just rebooting may not be a good solution if an SC occurs twice.
When an automatic reboot is performed, a confirmation screen is displayed after reboot. The confirmation screen
can be cancelled by pressing the [OK] key (display is not cancelled only when the main power switch is switched
OFF to ON).
Screen display during reboot
•
Status display on the current screen
•
Post-processing ...... Post-processing during printing, etc.
•
Automatic reboot .... After operation end
Post-processing
Until automatic reboot
•
Reset key (Reboot key)
Key to perform reboot
502