Ricoh SP 8400DN Field Service Manual page 1363

4.
The paper is put out on the staple tray. Put the paper next to the rear jogger [A].
5.
Measure the distance between the aligning side of the front jogger and the edge of the paper with a scale.
6.
Adjust the jogger width with SP6-143-004 (adjustable threshold: -1.5 to +1.5 mm for each paper size). SP6-
143-004 (Jogger Pos Adj:1K FIN)
Adjust the jogger width to be slightly narrower (approximately -0.5 mm) than the paper width.
7.
Repeat step 1 through step 5 to make the jogger width same as the paper width.
Maximum number of sheets for stapling and what happens when the job has too many pages
Behavior: When the number of sheets exceeds the maximum staple capability
When corner stapling
Sheets are fed out without being stapled. First, the maximum number of sheets (50) is stacked in the staple tray
and fed out. Following this, any remaining sheets that exceed this maximum are also stacked and fed out without
being stapled, in the same way.
Example:
If 60 sheets are set to be stapled, the first 50 are stacked in the staple tray and then fed out without being stapled.
The remaining 10 are then stacked in the tray and fed out without being stapled.
When the maximum number of originals for a stapled set has been scanned, "Stapling capacity exceeded" is
displayed on the LCD.
6.Troubleshooting
625