Ricoh SP 8400DN Field Service Manual page 1728

Ricoh a3 size black and white laser printer.

Hide thumbs Also See for SP 8400DN:

Table of Contents

Automatically chooses page orientations of PDF jobs (Landscape or Portrait) based on the

[Bit Switch]

Bit Switch 9

PDL Auto Detection timeout of jobs submitted via

USB or Parallel Port (IEEE 1284).

To be used if PDL auto-detection fails. A failure of PDL auto detection doesn't necessarily mean

that the job can't be printed. This bit switch tells the device whether to time-out immediately

(default) upon failure or to wait 10 seconds.

If this bit switch, all jobs will be cancelled after a jam occurs.

Note: If this bitsw is enabled, printing under the following conditions might result in problems:

- Job submission via USB or Parallel Port

- Spool printing (WIM >Configuration > Device Settings > System)

Timing of the PJL Status ReadBack (JOB END)

when printing multiple collated copies.

This bitsw determines the timing of the PJL USTATUS JOB END sent when multiple collated

copies are being printed.

0 (default): JOB END is sent by the device to the client after the first copy has completed

printing. This causes the page counter to be incremented after the first copy and then again at the

end of the job.

1: JOB END is sent by the device to the client after the last copy has finished printing. This

causes the page counter to be incremented at the end of each job.

Display UTF-8 text in the operation panel

Enabled (=0):

Text composed of UTF-8 characters can be displayed in the operation panel.

Disabled (=1):

UTF-8 characters cannot be displayed in the operation panel.

For example, job names are sometimes stored in the MIB using UTF-8 encoded characters.

When these are displayed on the operation panel, they will be garbled unless this BitSw is

enabled (=0).

Disable super option

4.Controller SP Mode Tables

(Immediately)

(10 seconds)

(Not cancelled)

Chapters

Table of Contents