Ricoh SP 8400DN Field Service Manual page 995

(SD card from which data is to be transferred) in Slot 2 [B].
4.
Turn ON the main power, and press [ENTER] in SP5-873-001 (SD Card Appli Move: Move Exec).
5. When a confirmation screen is displayed, press [ENTER] (it takes about 2 - 3 minutes).
•
If [CANCEL] is pressed, the display returns to the previous screen.
•
Note that if the power supply is turned off, a panel operation is performed, or the cover is opened
during merge, it will result in a malfunction.
6. When merge is complete, and the following screen is displayed, press [CLOSE].
•
If the process is terminated abnormally, perform the merge in SP mode again.
•
If the capacity of the destination SD card is insufficient, the merge operation cannot be performed.
7.
Press [END] twice.
8. Turn OFF the main power.
9.
Remove the empty SD card after transfer from Slot 2.
10. Reattach the slot cover [A]. (coin screw x 1)
11. Turn ON the main power, output the system setting list, and check that the options are recognized correctly.
Undo Exec
"Undo Exec" (SP5-873-002) lets you move back application programs from an SD card in Slot 1 (upper) to the
original SD card in Slot 2 (lower). You can use this program when, for example, you have mistakenly copied some
programs by using "Move Exec".
2.Installation
257