Ricoh SP 8400DN Field Service Manual page 1173

this reason, some of the SP modes shown on the screen need to be abbreviated. The following are abbreviations
used for the SP modes for which the full description is over 20 characters.
Item
Paper Weight
Paper Type
Paper Feed Station
Print Mode
Others
The settings of each SP mode are explained in the right-hand column of the SP table in the following way.
[Adjustable range / Default setting / Step] Alphanumeric
•
If "Alphanumeric" is written to the right of the bracket as shown above, the setting of the SP mode
shows on the screen using alphanumeric characters instead of only numbers. However, the settings in
the bracket in the SP mode table are explained by using only the numbers.
The following symbols are used in the SP mode tables.
Notation
ENG Engine SP
Controller SP
CTL
Factory setting: Data may be adjusted from the default setting at the factory. Refer to the factory
FA
setting sheets enclosed. You can find it in the front cover.
Design/Factory Use only: Do not touch these SP modes in the field.
DFU
An asterisk (*) to the left side of ENG/CTL column means that this mode is stored in the NVRAM.
*
If you do a RAM clear, this SP mode will be reset to the default value. "ENG" and "CTL" show
which NVRAM contains the data.
•
*ENG: NVRAM on the BCU board
•
*CTL: NVRAM on the controller board
2
Thin paper: 52-59 g/m
Plain Paper1: 60-74 g/m
Plain Paper2: 75-81 g/m
Middle Thick: 82-105 g/m
Thick Paper1: 106-169 g/m
Thick Paper2: 170-220 g/m
Thick Paper3: 221-256 g/m
Thick Paper4: 257-300 g/m
N: Normal paper
MTH: Middle thick paper
TH: Thick paper
P: Paper tray
B: By-pass table
S: Simplex
D: Duplex
Description
, 14-15lb. Bond
2
, 16-20lb. Bond
2
, 20lb. Bond
2
, 20-28lb. Bond
2
, 28lb. Bond-90lb. Index
2
, 65-80lb. Cover
2
, 80lb. Cover-140lb. Index
2
, 140lb. Index-110lb. Cover
What it means
5.System Maintenance
435