Ricoh SP 8400DN Field Service Manual page 1180

5.System Maintenance
update is complete, a "firmware update end screen" is displayed.
•
In the middle row, the name of the module currently being updated is displayed. (in this case, the printer
module is being updated)
•
In the lower row, a progress bar is displayed in ten steps. (The more *, the more the progress.)
<<Firmware update end screen>>
•
This screen is displayed when all selected firmware modules are to be updated. "Printer" in the second
row shows that the module updated last is the printer. (When more than one were updated
simultaneously, only the module that was updated last is displayed.)
•
When Verify has completed normally, the Update done display of the above screen is "Verify done." If
"Verify Error" is displayed, reinstall the software of the application displayed in the lower row.
11. After turning the main power OFF, remove the SD card.
12. Turn the main power ON again, and check whether the machine is operating normally.
13. Return the SD card slot cover to the original position.
•
When the power supply is switched OFF during firmware update, update is interrupted, and the power is
switched ON again, normal operation cannot be guaranteed.
•
To guarantee operation, an update error continues to be displayed until update is successful. In this case,
insert the SD card again, switch the power ON, and continue download of firmware from the SD card
automatically.
Error Screens During Updating
442