Ricoh SP 8400DN Field Service Manual page 1179

1. Press the module selection button or [1] - [5] on the 10-key pad.
2. Choose the appropriate module. (If already selected, cancel the selection)
Operation of keys or buttons
Keys or buttons to press
[Exit] or 10-key pad [0]
[Start] Key
[Clear/Stop] key
Display contents
On the above screen, two programs, i.e., engine firmware and printer application are displayed. (The screen
may change depending on the firmware or application).
The display contents are as follows:
Display
ROM: Display installed module number / version information.
NEW: Display module number / version information in the card.
The upper row corresponds to the module name, the lower row corresponds to the version number.
8. Select the module with the module selection button or 10 key pad operation. The selected module is
highlighted, and [Verify] and [Update] are displayed.
•
Depending on the combination of modules to update, it may not be possible to select all of them
simultaneously.
<<Key or button operations>>
Keys or buttons to press
[Update] or [#] key
[Verify] button or [./*] key
9. Press the [Update] or [#] key, and perform software update.
10. During firmware update, a "firmware update/ verification progress screen" is displayed. When firmware
Returns to normal screen.
Select all modules.
Cancel all selections.
Contents
Update the ROM of the selected module.
Perform verification of the selected module.
5.System Maintenance
Contents
Contents
441