Ricoh SP 8400DN Field Service Manual page 1182

5.System Maintenance
Code
The wrong card version is downloaded.
34 Destination error.
A card for the wrong destination is inserted.
35 Model error.
A card for the wrong model is inserted.
36 Module error.
The program to be downloaded does not
exist on the main unit.
The download destination specified by the
card does not match up to the destination for
the main unit's program.
38 The version of the downloaded program has
not been authorized for the update.
40 Engine download fails.
42 Control panel / language download fails.
43 Printing download fails.
44 The data to be overwritten cannot be
accessed when controller-related programs
are downloaded.
49 Firmware updates are currently prohibited.
50 The results of the electronic authorization
444
Contents
version in the SD card.
•
Install the correct ROM update data for each
destination (JPN/ EXP/ OEM) in the SD card.
•
Install the correct ROM update data for each
model in the SD card.
•
Install the program to be updated in advance.
•
There is a possibility that the SD card containing
the program to be updated has not been mounted.
Check to confirm that the SD card has been
correctly mounted.
•
The SD card is incorrect if the program to be
updated has been correctly installed. In this case,
insert the correct SC card.
•
Make sure that the program to be overwritten is
the specified version.
•
Switch the main power supply off and on to try
again.
•
If the download fails again, replace the controller
board and the BCU.
•
Switch the main power supply off and on to try
again.
•
If the download fails again, replace the controller
board and the operation panel unit.
•
Switch the main power supply off and on to try
again.
•
The SD card is damaged if the update fails again.
Replace the SD card.
•
Switch the main power supply off and on to try
again.
•
Install the correct ROM update data in the SD
card.
•
Replace the controller board if the data to be
overwritten is contained on the controller board.
•
The setting of Update Firmware in the
Administrator Tools has been set to [Prohibit] by
an administrator. Amend the setting to [Do not
Prohibit] and try again.
•
Install the correct ROM update data in the SD
Solutions