Honda SH300 2006 Manual page 491

DIAGNOSTIC CODE INDICATION
Disconnect the CKP sensor 2P (Red) connector.
Connect the inspection harness to the wire harness
side connector.
Connect the red clip of the adaptor to the 12 V bat-
tery positive (+) terminal and green clip to the nega-
tive (–) terminal.
TOOLS:
Inspection harness
Turn the ignition switch ON with the properly regis-
tered key.
The immobilizer indicator will come on for approx.
ten seconds then it will start blinking to indicate the
diagnostic code if the system is abnormal.
The blinking frequency is repeated.
The immobilizer indicator remains on when the sys-
tem is normal. (The system is in the normal mode
and the diagnostic code does not appear.)
DIAGNOSTIC CODE
When the system (ECM) enters the diagnostic mode from the normal mode:
07XMZ-MBW0101
BLINKING PATTERN
IMMOBILIZER SYSTEM (HISS)
INSPECTION HARNESS
IMMOBILIZER INDICATOR
SYMPTOM PROBLEM
ECM data is Faulty ECM
abnormal
Code signals Faulty immobi-
cannot send or lizer receiver or
receive wire harness
Identification Jamming by the
code is disagree other transpon-
der
Secret code is
disagree
2P (Red) CONNECTOR
12 V BATTERY
PROCEDURE
Replace the ECM
Follow the trouble-
shooting (page 23-
9)
Keep the other
vehicle's transpon-
der key away from
the immobilizer
receiver more than
50 mm (2.0 in)
23-7