Honda SH300 2006 Manual page 454

ELECTRIC STARTER
Connect the ground cables and tighten the two
mounting bolts.
Connect the starter motor cable.
Install and tighten the terminal nut to the specified
torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the rubber cap properly.
STARTER RELAY
OPERATION INSPECTION
Remove the maintenance lid (page 3-4).
Retract the sidestand.
Turn the ignition switch "ON" with the engine stop
switch at " ".
Squeeze rear brake lever fully and push the starter
switch.
The coil is normal if the starter relay clicks.
If you hear the starter relay "CLICK", but starter
motor does not turn, inspect the starter relay (page
21-15).
If you do not hear the starter relay "CLICK", inspect
the starter relay circuits (page 21-14).
CIRCUIT INSPECTION
RELAY COIL POWER INPUT LINE
Remove the maintenance lid (page 3-4).
Turn the engine stop switch " ".
Release the connector cover.
Measure the voltage between the starter relay 4P
(Red) connector terminal and ground with the igni-
tion switch turned to ON.
CONNECTION: Green/Yellow (+) – Ground (–)
There should be battery voltage only when the rear
brake lever squeezed and the starter switch is
pushed.
21-14
RUBBER CAP
STARTER MOTOR CABLE
BOLTS/GROUND CABLES
STARTER RELAY
G/Y (+)
4P (Red) CONNECTOR
TERMINAL NUT
Ground (–)