Honda SH300 2006 Manual page 392

HYDRAULIC BRAKE
ASSEMBLY
CALIPER BOLT
22 N·m (2.2 kgf·m, 16 lbf·ft)
CALIPER BODY
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
Coat a new dust seal with silicone grease, new pis-
ton seal with clean brake fluid and install them into
the seal grooves in the caliper cylinder.
Coat the caliper piston with clean brake fluid and
install it into the caliper cylinder with the opening
side toward the pad.
Check the caliper/bracket pin boots and replace
them if they are hard, deteriorated or damaged.
Apply 0.4 g minimum of silicone grease to the cali-
per/bracket pin boots, and install them into the cali-
per body and bracket.
Install the caliper pin to the pin boot as shown.
Install the caliper bracket to the caliper body.
17-34
CALIPER PIN BOLT
22 N·m (2.2 kgf·m, 16 lbf·ft)
CALIPER PISTON
CALIPER PIN
DUST SEAL
PISTON SEAL
PIN BOOT
PIN BOOT
PISTON SEAL
PIN BOOTS
CALIPER BODY
CALIPER BRACKET
RETAINERS
DUST SEAL
PISTON
RETAINERS
BRACKET
CALIPER PIN