Honda SH300 2006 Manual page 477

REMOVAL/INSTALLATION
Remove the following:
– Floor side cover (page 3-8)
– Floor panel (page 3-13)
Support the scooter securely using the centerstand.
Disconnect the sidestand switch 2P (Black) connec-
tor.
Release the sidestand switch wire from the wire
bands.
Remove the bolt and sidestand switch.
Install the sidestand switch by aligning its pin with
the sidestand hole and switch groove with the
bracket pin.
Install and tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the removed parts in the reverse order of
Route the side-
removal.
stand switch wire
properly (page 1-
19).
LIGHTS/METERS/SWITCHES
SIDESTAND SWITCH 2P
(BLACK) CONNECTOR
SIDESTAND SWITCH WIRE
SIDESTAND SWITCH
SIDESTAND SWITCH
Align (Pin/Groove)
WIRE BAND
BOLT
BOLT
Align (Tab/Hole)
22-21