Honda SH300 2006 Manual page 214

Table of Contents

ENGINE REMOVAL/INSTALLATION

Apply 1.0 – 2.0 g of grease to the inner collar, needle

bearings and dust seal lips.

Install the inner collar and dust seals to the engine

hanger bracket B.

Install the engine hanger bracket B to the engine

hanger bracket A and tighten the bolt/nut to the

specified torque.

TORQUE: 64 N·m (6.5 kgf·m, 47 lbf·ft)

Install the swing rod into the frame.

Install the upper bolt/nut, lower bolt/washer/nut and

tighten the nuts to the specified torque.

Upper: 42 N·m (4.3 kgf·m, 31 lbf·ft)

Lower: 52 N·m (5.3 kgf·m, 38 lbf·ft)

Install the engine hanger bracket to the frame and

loosely install the bolt and nut.

INNER COLLAR

ENGINE HANGER BRACKET

Chapters

Table of Contents