Honda SH300 2006 Manual page 373

Hold the rear caliper pin and tighten the rear caliper
bolt to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install the caliper to the swingarm so that the disc is
positioned between the pads, being careful not to
damage the pads.
Install the new brake caliper mounting bolts and
tighten them to the specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Operate the rear brake lever to seat the caliper pis-
ton against the pads.
Install the following:
– brake hose protector (page 16-11)
– exhaust pipe/muffler (page 3-15)
BRAKE DISC INSPECTION
Visually inspect the brake disc for damage or cracks.
Measure the brake disc thickness at several points.
SERVICE LIMITS:
FRONT: 3.5 mm (0.14 in)
REAR: 4.0 mm (0.16 in)
Measure the brake disc warpage with a dial indica-
tor.
SERVICE LIMITS:
FRONT: 0.25 mm (0.010 in)
REAR: 0.25 mm (0.010 in)
Check the bearing for excessive play, if the warpage
exceeds the service limit.
Replace the brake disc if the bearings are normal.
For front brake disc replacement, refer to page 15-8.
For rear brake disc replacement, refer to page 16-7.
HYDRAULIC BRAKE
CALIPER PIN
MOUNTING BOLTS
CALIPER BOLT
CALIPER
17-15