Honda SH300 2006 Manual page 428

BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL/INSTALLATION
Remove the maintenance lid (page 3-4).
Always turn the
ignition switch OFF
Remove the bolts and battery holder plate.
before removing
the battery.
Remove the bolt and disconnect the negative (–)
Disconnect the
cable.
negative terminal
Remove the bolt and disconnect the positive (+)
first, then the posi-
cable.
tive terminal.
Remove the battery.
Install the battery in the reverse order of removal.
Connect the posi-
tive terminal first,
After installing the battery, coat the terminals with
then the negative
clean grease.
terminal.
Install the maintenance lid (page 3-4).
VOLTAGE INSPECTION
Remove the maintenance lid (page 3-4).
Measure the battery voltage using a digital
multimeter.
VOLTAGE:
Fully charged:
Needs charging: Below 12.3 V
If the battery voltage is below 12.3 V, charge the bat-
tery.
19-6
Above 12.8 V
BATTERY HOLDER PLATE
BOLTS
BATTERY
POSITIVE (+)
CABLE
POSITIVE (+)
TERMINAL
NEGATIVE (–)
TERMINAL
NEGATIVE (–)
TERMINAL