Honda SH300 2006 Manual page 326

FRONT WHEEL/SUSPENSION/STEERING
Tighten the front side axle holder socket bolt, then
tighten the rear side axle holder socket bolt to the
specified torque.
TORQUE: 36 N·m (3.7 kgf·m, 27 lbf·ft)
Measure the clearance (air gap) between the sensor
ABS type only.
and pulser ring at several points by turning the
wheel slowly.
It must be within specification.
STANDARD: 0.2 – 1.2 mm (0.01 – 0.05 in)
The sensor air gap cannot be adjusted.
If it is not within specification, check each installa-
tion part for deformation, looseness and damage.
FORK
REMOVAL
Remove the following:
Support the brake
caliper so it does
– front wheel (page 15-6)
not hang from the
– front fender (page 3-8)
brake hose. Do not
Remove the following from left fork:
twist the brake
hose.
– two mounting bolts
– brake caliper
Remove the upper pinch bolt.
Loosen the lower pinch bolt and remove the fork
leg.
15-12
SOCKET BOLTS
MOUNTING BOLTS
Remove
CALIPER
Loosen
FORK