Honda SH300 2006 Manual page 21

MATERIAL
Grease
(Shell ALVANIA R3 or SHIN-
NIHON POWERNOC WB3 or
IDEMITSU AUTOREX B or
equivalent)
Multi-purpose grease
Locking agent
Degrease
LOCATION
Driven face boss inner surface
Movable driven face guide grooves (guide pin
areas)
Movable driven face ball and needle bearing
Each oil seal lips
Oil filter boss crankcase side threads
Centerstand spring hook bolt threads
Cam stopper plate bolt threads
Cam sprocket bolt threads
Cylinder head sealing bolt threads
Starter clutch outer socket bolt threads
Starter driven gear guide bolt threads
Right and left crankcase sealing torx bolt threads
Flywheel tapered area
Water pump shaft (mechanical seal area)
Drive/driven pulley face and drive belt
GENERAL INFORMATION
REMARKS
Fill up 5 – 7 g
Fill up 4 – 5 g
Coating width: 6.5 ± 1.0 mm
(0.26 ± 0.04 in) from its tip
Coating width: 6.5 ± 1.0 mm
(0.26 ± 0.04 in) from its tip
Coating width: 6.5 ± 1 mm
(0.26 ± 0.04 in) from its tip
to 2.0 – 3.0 mm (0.08 – 0.12
in) down
Coating width: 6.5 ± 1.0 mm
(0.26 ± 0.04 in) from its tip
Coating width: 6.5 ± 1.0 mm
(0.26 ± 0.04 in) from its tip
Coating width: 6.5 ± 1.0 mm
(0.26 ± 0.04 in) from its tip
1-17