Honda SH300 2006 Manual page 376

HYDRAULIC BRAKE
Measure the master cylinder I.D.
SERVICE LIMIT: 11.055 mm (0.4352 in)
Measure the master cylinder piston O.D.
SERVICE LIMIT: 10.945 mm (0.4309 in)
ASSEMBLY
BOOT
MASTER PISTON
BRAKE LEVER
• Replace the piston, spring, cups, snap ring and
boot as a set.
Coat the master piston and piston cups with clean
DOT 4 brake fluid.
Install the spring onto the master piston.
Install the spring and master piston into the master
Do not allow the
cylinder.
piston cup lips to
turn inside out.
17-18
SNAP RING
WASHER
PISTON CUPS
PIVOT BOLT
1 N·m (0.1 kgf·m, 0.7 lbf·ft)
SPRING
PIVOT NUT
6 N·m (0.6 kgf·m, 4.4 lbf·ft)
SCREWS
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
CAP
DIAPHRAGM PLATE
DIAPHRAGM
MASTER CYLINDER
BRAKE LIGHT SWITCH
SCREW
1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
SPRING
CUPS
MASTER PISTON