Honda SH300 2006 Manual page 465

GROUND LINE
Remove the front handlebar cover (page 3-14).
Disconnect the combination meter 16P connector.
Check for continuity between the Green wire termi-
nal of the 16P connector of the wire harness side
and ground.
There should be continuity at all times.
If there is no continuity, check for an open circuit in
the Green wire.
BACK-UP VOLTAGE LINE
Measure the voltage between the Light green/Black
wire terminal (+) of the 16P connector of the wire
harness side and ground (–).
There should be battery voltage at all times.
If there is no voltage, check the following:
– Open circuit in the Light green/Black wire
– Blown "CLOCK" fuse (10 A)
– Open circuit between the Red wire between the
fuse box and battery
REMOVAL/INSTALLATION
Remove the rear handlebar cover (page 3-14).
Disconnect the following:
– Engine stop switch 4P connector
– Starter switch 4P connector
– Dimmer switch 4P connector
– Turn signal switch 3P connector
– Horn switch 2P connector
Remove the three screws and combination meter.
LIGHTS/METERS/SWITCHES
16P CONNECTOR
(Wire side of female
terminal)
METER 16P
CONNECTOR
16P CONNECTOR
(Wire side of female
terminal)
METER 16P
CONNECTOR
COMBINATION
METER
TURN SIGNAL
ENGINE STOP
SWITCH 3P
SWITCH 4P
CONNECTOR
CONNECTOR
STARTER
SWITCH 4P
CONNECTOR
SCREWS
G
Lg/Bl
DIMMER SWITCH
4P CONNECTOR
HORN SWITCH 2P
CONNECTOR
22-9