Honda SH300 2006 Manual page 420

ANTI-LOCK BRAKE SYSTEM (ABS; SH300A/AII/AIII)
Remove the four socket bolts and sensor protector.
Remove the two bolts and rear wheel speed sensor.
Check that there is iron or other magnetic deposits
between the pulser ring and wheel speed sensor.
Remove any deposits.
Check the sensor tip for deformation or damage
(e.g., chipped pulser ring teeth).
Replace the speed sensor if necessary.
Installation is in the reverse order of removal.
Route the sensor
wire properly (page
• Replace the sensor protector socket bolt with
1-19).
new ones.
TORQUE: Sensor protector socket bolt
After installing the speed sensor, Measure the clear-
ance (air gap) between the sensor and pulser ring
(page 18-25).
18-26
10 N·m (1.0 kgf·m, 7 lbf·ft)
SENSOR PROTECTOR
SOCKET BOLTS
BOLTS
REAR WHEEL
SPEED SENSOR