Honda SH300 2006 Manual page 323

Install the remover head into the bearing.
Replace the wheel
From the opposite side of the wheel, install the
bearings in pairs.
bearing remover shaft and drive the bearing out of
Do not reuse old
the wheel hub.
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head, 15 mm
Remove the distance collar and drive out the other
bearing.
ASSEMBLY
DUST SEAL
BEARING (6302U)
DISTANCE COLLAR
Pack the cavity in bearing with grease.
Drive in a new left side bearing (brake disc side)
squarely with the sealed side facing up until it is
fully seated.
Install the distance collar.
Drive in a new right side bearing squarely with the
sealed side facing up until it is fully seated.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 15 mm
07746-0050100
07746-0050400
BEARING (6302U)
BRAKE DISC
07749-0010000
07746-0010300
07746-0040300
FRONT WHEEL/SUSPENSION/STEERING
REMOVER HEAD
DUST SEAL
SOCKET BOLT
42 N·m (4.3 kgf·m, 31 lbf·ft)
TORX BOLT
8 N·m (0.8 kgf·m, 5.9 lbf·ft)
BEARING
REMOVER SHAFT
ABS type:
PULSER RING
DRIVER
ATTACHMENT
/PILOT
15-9