Honda SH300 2006 Manual page 388

HYDRAULIC BRAKE
ASSEMBLY
CALIPER PISTON
DUST SEAL
PAD SPRING
Coat new piston seals with clean brake fluid, new
dust seals with silicone grease and install them into
the seal grooves in the caliper cylinder.
Coat the caliper pistons with clean brake fluid and
install them into the caliper cylinders with the open-
ing sides toward the pads.
Check the caliper/bracket pin boots and replace
them if they are hard, deteriorated or damaged.
Install the pad spring onto the caliper body as
shown.
Apply 0.4 g minimum of silicone grease to the cali-
per/bracket pin boots, and install them into the cali-
per body and bracket.
Install the caliper bracket to the caliper body.
17-30
CALIPER BRACKET
PISTON SEAL
CALIPER PIN BOOT
RETAINER
BRACKET PIN BOOT
BRACKET PIN BOLT
12 N·m (1.2 kgf·m, 9 lbf·ft)
CALIPER PIN BOLT
22 N·m (2.2 kgf·m, 16 lbf·ft)
CALIPER BLEED VALVES
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
PISTON SEALS
PIN BOOTS
CALIPER BODY
CALIPER BODY
DUST SEALS
PISTONS
CALIPER BRACKET
PAD SPRING RETAINER