Honda SH300 2006 Manual page 165

ASSEMBLY
TORX SCREWS
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
SENSOR UNIT
Install the new O-ring to the throttle body.
• Install the O-ring to the throttle body properly. If
the O-ring is not installed properly, the idle air
will leak and engine idle speed will be unstable.
Install the sensor unit to the throttle body by align-
ing the clip of the TP sensor and boss of the throttle
valve.
• The light pressure is sufficient to assemble the
sensor unit and throttle body in their correct
position. If you cannot assemble them easily, the
clip may be misaligned. Do not attempt to force
them together and make sure that the clip is
aligned.
• Perform the TP sensor reset procedure (page 6-
58) after installing the sensor unit.
Install and tighten the torx screws to the specified
torque.
TORQUE: 3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)
SCREW
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
THROTTLE BODY
O-RING
TORX SCREWS
2.1 N·m (0.2 kgf·m,
IACV
1.5 lbf·ft)
FUEL SYSTEM (PGM-FI)
WIRE CLAMP
PLATE
SET PLATE
THROTTLE BODY
O-RING
THROTTLE CABLE
BRACKET
SCREW
3.4 N·m (0.3 kgf·m,
2.5 lbf·ft)
Align
SENSOR UNIT
TORX SCREWS
6-55