Honda SH300 2006 Manual page 236

CYLINDER HEAD/VALVES
Route the cam chain through the cylinder head and
install the cylinder head.
Apply molybdenum oil solution to the thread and
seating surface of the cylinder head 9 mm bolts and
washers.
Install the 9 mm bolts, washers and tighten the bolts
in a crisscross pattern in 2 or 3 steps to the specified
torque.
TORQUE: 38 N·m (3.9 kgf·m, 28 lbf·ft)
Install the two cylinder head 6 mm bolts and tighten
them.
Connect the water hose.
Install the two bolts and clamp stay.
Install the main wire harness wire band, CKP sensor
Route the wires
wire band, ignition coil wire band and spark plug
properly (page 1-
wire band to the stay.
19).
Install the following:
– spark plug (page 4-7)
– camshaft/rocker arm (if removed) (page 9-21)
– cam sprocket (page 9-22)
– cylinder head cover (page 9-24)
– O sensor (page 6-76)
2
– ECT sensor (page 6-75)
– thermostat (page 7-9)
– intake manifold (page 6-64)
– exhaust pipe/muffler (page 3-15)
Fill the engine oil (page 4-11).
Fill and bleed the cooling system (page 7-7).
9-20
BOLTS/WASHERS
BOLTS
HOSE
STAY
BANDS
CYLINDER HEAD
BOLTS