Honda SH300 2006 Manual page 264

DRIVE AND DRIVEN PULLEYS/CLUTCH
DRIVEN FACE BEARING REPLACE-
MENT
Remove the driven face needle bearing using the
special tools.
TOOLS:
Bearing remover set, 25 mm 07936-ZV10100
Remover weight
Remove the snap ring and remove the ball bearing.
Pack new ball bearing cavity with grease.
Press the ball bearing into the driven face with the
sealed side facing down until it is fully seated using
the special tool.
TOOLS:
Driver
Pilot, 28 mm
Install the snap ring to the groove in the driven face
securely.
Apply 5 – 7 g of grease (Shell ALVANIA R3 or SHIN-
NIHON POWERNOC WB3 or IDEMITSU AUTOREX B
or equivalent) to the driven face boss inner surface.
11-14
07741-0010201
07749-0010000
07746-0041100
(5 – 7 g)
BEARING REMOVER
WEIGHT
BALL BEARING
NEEDLE BEARING
SNAP RING
BALL
BEARING
DRIVER/PILOT
SNAP RING
BALL
BEARING