Honda SH300 2006 Manual page 238

Table of Contents

CYLINDER HEAD/VALVES

Shift the rocker arms to the spring side and install

Be careful not to let

the shims in their original locations on the valve

the shims fall into

the crankcase.

CAM SPROCKET INSTALLATION

Rotate the drive pulley (crankshaft) counterclock-

Be careful not to

wise and align the "T" mark on the flywheel with the

jam the cam chain

index notch in the crankcase cover.

and timing sprocket

on the crankshaft

when rotating the

Apply engine oil to the cam chain and sprocket

Install the cam sprocket onto the cam chain so that

the index line on the cam sprocket is flush with the

cylinder head surface.

Install the cam sprocket onto the camshaft.

Cover the cylinder head with a shop towel to pre-

vent sprocket bolt from falling into the crankcase.

Apply locking agent to the sprocket bolt threads

(page 1-16).

Align the bolt holes in the sprocket and camshaft.

Install the sprocket bolts and tighten them while

holding the drive pulley (crankshaft).

TORQUE: 16 N·m (1.6 kgf·m, 12 lbf·ft)

Chapters

Table of Contents