Honda SH300 2006 Manual page 269

DRIVE AND DRIVEN PULLEYS/CLUTCH
INSTALLATION
Install the clutch/driven pulley assembly with the
drive belt (page 11-7).
COLLAR
Clean any oil and grease from the clutch outer.
Install the clutch outer onto the driveshaft by align-
ing the spline.
Apply grease to the new O-rings and install its to the
bearing collar grooves.
Apply molybdenum disulfide paste (SUMICO MOLY-
PASTE 300 or 500 or equivalent) to the bearing col-
lar groove.
Install the bearing collar onto the driveshaft.
O-RINGS
Install the clutch outer nut onto the driveshaft.
NUT
CLUTCH OUTER
Hold the clutch outer with the special tool and
tighten the clutch outer nut to the specified torque.
TOOL:
Flywheel holder 07725-0040001
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
Install the drive pulley face (page 11-9).
FLYWHEEL HOLDER
11-19