Honda SH300 2006 Manual page 260

DRIVE AND DRIVEN PULLEYS/CLUTCH
Clean any oil and grease from the weight rollers.
Install the weight rollers on the movable drive face.
Install the slide piece and ramp plate.
Clean any oil and grease from the drive face and the
drive belt.
Install the drive face boss into the movable drive
face assembly.
Install the movable drive face assembly onto the
crankshaft while holding the ramp plate.
Install the drive belt onto the drive face boss.
Clean any oil and grease from the drive pulley face.
Install the drive pulley face.
Apply engine oil to the threads and seating surface
of the drive pulley face bolt.
Install the washer and drive pulley face bolt.
Hold the drive pulley face with the special tool and
tighten the bolt to the specified torque.
TOOL:
Universal holder
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Install the left crankcase case cover (page 11-6).
11-10
WEIGHT ROLLERS
DRIVE BELT
DRIVE FACE BOSS
DRIVE
PULLEY FACE
07725-0030000
UNIVERSAL HOLDER
RAMP PLATE
BOLT/WASHER
DRIVE PULLEY FACE
BOLT
SLIDE PIECES
MOVABLE
DRIVE FACE