Honda SH300 2006 Manual page 356

REAR WHEEL/SUSPENSION
INSTALLATION
Install the rear wheel onto the final gear shaft, align-
ing the spline.
Apply 0.03 – 0.04 g grease to the groove of the final
gear shaft.
Apply grease to bearing fitting area of the final gear
shaft.
Install the inside/outside collars into the swingarm.
Install the swingarm and tighten the swingarm
mounting bolts to the specified torque.
TORQUE: 49 N·m (5.0 kgf·m, 36 lbf·ft)
Install the rear axle nut and temporarily tighten it.
Set the right rear shock absorber and tighten the
rear shock absorber lower mounting bolt.
16-10
GROOVE (0.03 – 0.04 g)
INSIDE COLLAR
BOLTS
AXLE NUT
MOUNTING BOLT
OUTSIDE COLLAR
SWINGARM