Honda SH300 2006 Manual page 389

INSTALLATION
Install the front brake caliper onto the left fork leg.
Install new mounting bolts and tighten them to the
specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Connect the brake hoses to the front brake caliper
with the oil bolts and new sealing washers.
Tighten the brake hose oil bolts to the specified
torque while setting the hose joints against the
stoppers on the caliper body.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the brake pads (page 17-13).
Fill brake fluid and bleed air the hydraulic system
(page 17-7).
Set the front wheel speed sensor and tighten the
ABS type only.
bolts.
Set the lower wire clamp and tighten the clamp bolt.
ABS type only.
Route the sensor
Set the wire guide and upper wire clamp then
wire properly (page
tighten the clamp bolt.
1-19).
HYDRAULIC BRAKE
MOUNTING BOLTS
OIL BOLTS/
SEALING WASHERS
WHEEL SPEED SENSOR
CLAMP BOLTS
BRAKE CALIPER
BRAKE
HOSES
STOPPERS
BOLTS
GUIDE
17-31