Honda SH300 2006 Manual page 354

REAR WHEEL/SUSPENSION
Turn the inner race of the bearing with your finger.
The bearing should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the swingarm.
Replace the bearing if the inner race does not turn
smoothly and quietly, or if the outer race fits
loosely.
Drive the bearing out of the swingarm.
Drive in a new bearing into the swingarm squarely
until it is fully seated, using the special tools.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 17mm
Install the snap ring into the swingarm groove
securely with the chamfered side facing the bearing.
Apply grease to the lips of new dust seals.
Install each dust seal until it is flush with the
swingarm.
16-8
07749-0010000
07746-0010300
07746-0040400
DUST SEALS
DRIVER
ATTACHMENT/PILOT
BEARING
SNAP RING