Honda SH300 2006 Manual page 261

CLUTCH/DRIVEN PULLEY
REMOVAL
Remove the drive pulley face (page 11-8).
Hold the clutch outer with the special tool and
loosen the clutch outer nut.
TOOL:
Flywheel holder
Remove the nut, bearing collar and clutch outer.
Remove the O-rings from the bearing collar.
Remove the clutch/driven pulley assembly with the
drive belt from the driveshaft.
Remove the drive belt from the driven pulley.
CLUTCH OUTER/SHOE LINING INSPECTION
Check the clutch outer for wear or damage.
Measure the clutch outer I.D.
SERVICE LIMIT: 135.5 mm (5.33 in)
DISASSEMBLY
CLUTCH/DRIVEN PULLEY
Set the clutch spring compressor onto the clutch/
driven pulley assembly by aligning the bosses with
the holes in the clutch.
TOOL:
Clutch spring compressor
DRIVE AND DRIVEN PULLEYS/CLUTCH
FLYWHEEL HOLDER
07725-0040001
07LME-GZ40201
CLUTCH/DRIVEN PULLEY ASSEMBLY
COLLAR/O-RINGS
CLUTCH OUTER
NUT
DRIVE BELT
CLUTCH/DRIVEN
PULLEY ASSEMBLY
SPRING COMPRESSOR
11-11