FINAL REDUCTION
Install the two dowel pins.
Apply sealant (Three Bond 1207B or equivalent) to
the final reduction case mating surface as shown.
Install the final reduction case to the left crankcase.
Install and tighten the seven bolts in a crisscross
pattern in 2 or 3 steps to the specified torque.
TORQUE: 24 N·m (2.4 kgf·m, 18 lbf·ft)
Fill the final reduction case with the recommended
oil (page 4-17).
Install the following:
– rear wheel speed sensor (page 18-25)
ABS type only.
– sensor protector (page 18-25)
– rear wheel (page 16-10)
– clutch/driven pulley (page 11-19)
12-12
FINAL REDUCTION CASE
DOWEL PINS
BOLTS