Honda SH300 2006 Manual page 349

SERVICE INFORMATION
GENERAL
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with a high quality brake degreasing agent.
• After rear wheel installation, check the brake operation by applying the brake lever.
• When servicing the rear wheel and suspension, support the scooter using a safety stand or hoist.
• Use only tires marked "TUBELESS" and tubeless valve stems on rims marked "TUBELESS TIRE APPLICABLE".
• Use genuine Honda replacement bolts and nuts for all suspension pivot and mounting point.
• For brake system service (page 17-4).
SPECIFICATIONS
Minimum tire tread depth
Cold tire Driver only
pressure
Driver and passenger
Wheel Rim runout
Balance weight
TORQUE VALUES
Rear brake caliper mounting bolt
Swingarm mounting bolt
Rear axle nut
Rear brake disc socket bolt
Rear pulser ring torx bolt (ABS type only)
TOOLS
Driver
07749-0010000
ITEM
Radial
Axial
30 N·m (3.1 kgf·m, 22 lbf·ft)
49 N·m (5.0 kgf·m, 36 lbf·ft)
118 N·m (12.0 kgf·m, 87 lbf·ft)
42 N·m (4.3 kgf·m, 31 lbf·ft)
8 N·m (0.8 kgf·m, 5.9 lbf·ft)
Attachment, 42 x 47 mm
07746-0010300
REAR WHEEL/SUSPENSION
STANDARD
–
2
225 kPa (2.25 kgf/cm , 33 psi)
2
225 kPa (2.25 kgf/cm , 33 psi)
–
–
–
ALOC bolt; replace with a new one
U-nut
ALOC bolt; replace with a new one
ALOC bolt; replace with a new one
Pilot, 17 mm
07746-0040400
Unit: mm (in)
SERVICE LIMIT
2.0 (0.08)
–
–
2.0 (0.08)
2.0 (0.08)
70 g (2.5 oz)
maximum
16-3