Honda SH300 2006 Manual page 377

Install the washer and snap ring into the groove in
the master cylinder.
TOOL:
Snap ring pliers
• Install the snap ring with the chamfered edges
facing the thrust load side.
• Check that the snap ring is seated in the grooves.
Apply silicone grease to the piston boot inner sur-
face.
Install the piston boot into the master cylinder and
the piston groove.
Instal the brake light switch by aligning the boss of
the switch body and hole of the master cylinder.
Install and tighten the screw to the specified torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
Apply 0.1 g of silicone grease to the contact sur-
faces of the brake lever, piston tip and brake lever
pivot bolt sliding surface.
Install the brake lever.
Install the pivot bolt and tighten it to the specified
torque.
TORQUE: 1 N·m (0.1 kgf·m, 0.7 lbf·ft)
Install the pivot nut and tighten it to the specified
torque.
TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)
07914-SA50001
BRAKE LEVER
HYDRAULIC BRAKE
WASHER
SNAP RING PLIERS
PISTON BOOT
BRAKE LIGHT SWITCH
Align
SCREW
PIVOT BOLT
SNAP RING
PIVOT NUT
17-19