Honda SH300 2006 Manual page 168

FUEL SYSTEM (PGM-FI)
TP SENSOR RESET PROCEDURE
• Make sure that DTC is not stored in ECM. If the
DTC is stored in ECM, TP sensor reset mode
won't start by following the procedure below.
1. Remove the maintenance lid (page 3-4).
2. Turn the ignition switch "OFF".
3. Remove the dummy connector from the DLC.
4. Connect the special tool to the DLC and short the
DLC terminals.
TOOL:
SCS connector
CONNECTION: Brown – Green/Black
5. Disconnect the ECT sensor 3P (Gray) connector.
Short the ECT sensor terminals with jumper wire.
CONNECTION: Pink/White – Green/Orange
6-58
DUMMY CONNECTOR
SCS CONNECTOR
070PZ-ZY30100
3P (GRAY)
CONNECTOR
DLC
JUMPER WIRE