Honda SH300 2006 Manual page 173

Table of Contents

Insert a new retainer into the connector.

• Always replace the retainer of the quick connect

fitting when the fuel hose is disconnected.

• If any retainer needs replacing, use the same

manufacturer's retainer as the ones being

removed (The several manufacturers feature dif-

ferent retainer specifications).

Clean around the pipe and set the rubber correctly.

Align the quick connect fitting with the pipe and

Do not bend or

align the retainer locking pawls with the connector

twist fuel hose.

Then press the quick connect fitting onto the pipe

until both retainer pawls lock with a "CLICK".

If it is hard to connect, put a small amount of engine

oil on the pipe end.

Make sure the connection is secure and that the

pawls are firmly locked into place; check visually

and by pulling the connector.

Set the fuel feed hose.

Install and tighten the fuel hose clamp bolt.

Connect the injector 2P connector by aligning the

connector stopper with the tab on the fuel feed pipe.

Connect the quick connect fitting of the fuel pump

side (page 6-45).

FUEL SYSTEM (PGM-FI)

FUEL FEED HOSE CLAMP BOLT

INJECTOR 2P CONNECTOR

LOCKING PAWLS

Chapters

Table of Contents