Honda SH300 2006 Manual page 325

Set the axle holder with the "F" mark facing forward
Right fork only:
and temporarily install the new axle holder socket
bolts and washers.
Install the front wheel between the fork legs while
Be careful not to
inserting the brake disc between the pads in caliper.
damage the brake
pads.
Install the front axle from the right side.
Hold the axle and tighten the axle nut to the speci-
fied torque.
TORQUE: 98 N·m (10.0 kgf·m, 72 lbf·ft)
With the front brake applied, pump the forks up and
down several times to seat the axle and check brake
operation.
FRONT WHEEL/SUSPENSION/STEERING
"F" MARK
HOLDER
AXLE
SOCKET BOLTS/
WASHERS
NUT
15-11